Step 3: Verify That The Printing Platform Is Not Dirty; Step 4: Adjust The Initial Printing Height (Z0) - Roland DWP-80S User Manual

1. Preparing the Machine
H
Fully tighten the liquid material vat retaining screws.
Step 3: Verify that the Printing Platform is Not Dirty
Before starting printing, check that there is no dirt or foreign matter on the printing platform (such as fragments
remaining from the last printing operation).
If dirt or foreign matter is present, wash the printing platform.
" P. 36 "1. Wash the printing platform."
Step 4: Adjust the Initial Printing Height (Z0)
When setting the liquid material vat for the first time or when replacing the liquid material vat, it is necessary to
adjust the height at which the job starts to be made in the liquid material vat.
Procedure
A
Using the included hexagonal screwdriver, loosen the Z0 adjustment screws.
Verify that the printing platform can be moved up and down by hand.
20
Chapter 2 Output
Z0 adjustment screw