Roland DWP-80S User Manual page 40

3. Printing
D
Transfer the resin remaining in the liquid material vat to the light-shielding bottle.
To remove debris created during printing, strain the resin and then move the resin to the light-shielding
bottle. Resin transferred to the light-shielding bottle can be reused (so long as the expiration date has
not passed).
Plastic
spatula
Light-shielding
bottle
N O T E
• Use the included plastic spatula to clean the liquid material vat. If the metallic spatula is used to clean the
liquid material vat, the bottom of the vat (silicon material) may be scratched, making it impossible to print.
• Resin can be reused so long as the expiration date has not passed.
E
Soak a rag or other cloth in ethanol and wipe away any resin that remains in the liquid
material vat.
Be sure to remove any resin adhering to the liquid material vat. Allowing the resin to remain can cause
the liquid material vat to deteriorate and printing to fail.
F
Dry the liquid material vat completely.
G
Install the liquid material vat as before.
3.
Clean the work tray.
Use a rag to wipe away any resin that has adhered to the work tray surface.
Resin has a tendency to adhere to the platform and the area where the job is placed, so check these
locations carefully and wipe away any resin.
I m p o rt an t
Be sure to remove all the resin that has adhered to the work tray. Allowing the resin to remain can cause the resin
to cure, which may lead to the work tray deteriorating to the point where it can no longer be used.
40
Chapter 2 Output
Liquid material vat
Strainer
Funnel