Table of Contents
Advertisement
2.
Add resin to the liquid material vat.
M E M O
Adjust the height of the printing machine legs before use. Adjust the legs so that the resin will collect on the
printing platform side (the back of the machine) when the amount of resin in the liquid material vat gets low. For
details, refer to the "DWP-80S Setup Guide."
A
Wear rubber gloves (included or commercially available) and protective eyewear
(commercially available).
B
Shake the resin bottle to mix the resin.
Make sure the bottle's cap is tight, and then turn the bottle over and shake according to the following
guidelines. If agitation is insufficient, the color of the resin may be uneven in some parts when cured.
•
New products and products that have not been used for a long period of time: Approx.
120 times per minute
•
All other products: Approx. 60 times per 30 seconds
C
Fill the liquid material vat with resin.
Ensure all of the surfaces inside the liquid material vat are coated with resin. At this point, the amount
under [Estimated job volume] in Quick Denta should show an increase of approximately 100 g.
M E M O
• A resin volume of 100 ml is equivalent to approximately 110 g.
I m p o r t a n t
Do not use different types of resin mixed together.
D
Close the lid of the resin bottle securely.
I m p o rt an t
If the lid of the resin bottle is not closed securely, the remaining resin may deteriorate or cure, making it
impossible to use.
Do not fill with resin beyond
the FULL line.
3. Printing
Chapter 2 Output
29
Advertisement
Table of Contents
