Table of Contents
Advertisement
3. Printing
Step 2: Send the Print Data
CAUTION
CAUTION
Procedure
A
Complete the pre-print confirmations.
Confirm the following points before printing. If the following points are not confirmed, output may stop,
causing the printing to fail.
•
The computer's display settings have been optimized for the machine. (P. 11
"Optimizing the Display Settings for the Machine")
•
A secondary monitor (an external display monitor) is not connected.
•
When using a laptop computer, the computer is connected to an AC adapter and power
is being supplied.
•
The liquid material vat has been installed. (P. 17 "Step 2: Install the Liquid Material
Vat in the Machine"
•
The preview has been checked. (P. 28 "1. Check the preview and the estimated job
volume for the resin.")
B
Click [Print].
This starts the printing operation. Wait a few minutes until printing is complete.
I m p o rt an t
Do not open the front cover during printing. Doing so may result in reduced print quality.
30
Chapter 2 Output
Under no circumstances should you move the Z-axis unit with your hands.
Doing so may cause a breakdown.
When handling resin, wear rubber gloves and protective eyewear.
Do not allow resin to come into contact with the skin or eyes.
Advertisement
Table of Contents
