Playing The Input Source - Denon AVR-3806 Operating Instructions Manual

ENGLISH
Basic Operation
VIDEO SELECT
FUNCTION STANDARD
SOURCE PHONES EXT.IN
INPUT MODE ANALOG
INPUT MODE
STANDARD
ROOM EQ
MUTING
FUNCTION

Playing the input source

VOLUME
1
Select the input source to be played.
Example: CD
(Main unit)
To select the input source when ZONE2/3/REC SELECT,
ROOM EQ
VIDEO SELECT or TUNING PRESET is selected, press the
SOURCE button on the main unit then operate the FUNCTION
knob.
2
Start playback on the selected component.
For operating instructions, refer to the component's manual.
3
Adjust the volume.
VIDEO SELECT
SPEAKER
(Main unit)
VOLUME
The volume level is displayed on the master volume level display.
The volume can be adjusted within the range of –80 to +18
dB, in steps of 0.5 dB. However, when the channel level is
set ( page 40 or 75, 76), if the volume for any channel is
set at +0.5 dB or greater, the volume cannot be adjusted up
to 18 dB. (In this case the maximum volume adjustment
range is "18 dB — (Maximum value of channel level)".)
Also, you may not be able to adjust the volume to the
maximum of 18 dB when internal volume compensation
control is activated due to the combination of the surround
mode and parameters, downmixing from multi-channel
audio signals into two channels, etc.
(Remote control unit)
(Remote control unit)
M.VOL. -80.0dB
25
ENGLISH
2 To choose the surround sound mode
Example: Dolby Digital
STANDARD
Press the button.
For more information about the surround modes (
31, 32).
2 To select the Room EQ function
ROOM EQ
Press the button.
For more information about the Room EQ function (
page 28).
Basic Operation
page