Zone2 / Zone3 Speaker Out Connections; Connecting The Pre-Out Terminals; Connecting The Power Supply Cord - Denon AVR-3806 Operating Instructions Manual

ENGLISH
Connecting Other Sources

ZONE2 / ZONE3 speaker out connections

• When the surround back's power amplifier is assigned to the ZONE2 or ZONE3 output channel
at "Power Amp Assign" in the "System Setup Menu", the surround back speaker terminals can
be used as the ZONE2 or ZONE3 speaker out terminals (
• The connections diagram below is an example for when the surround back speaker is assigned
to the ZONE2 stereo 2 channel.
In this case, surround back speaker out can not be used for MAIN ZONE.
Subwoofer
Connection
terminal for
subwoofer
with built-in
amplifier
(subwoofer),
IN
etc.
( L )
( R )
> <
> <
Front speaker
systems
page 55).
Surround Surround
Center
speaker speaker
speaker
systems (A) systems (B)
( L ) ( R ) ( L )
> < > < > <
> <
( L )
( R )
> < > <
ZONE2
Front speaker
systems
ZONE2

Connecting the pre-out terminals

• Use these terminals if you wish to connect external power amplifier(s) to increase the power of
the front, center, surround and surround back sound channels, or for connection to powered
loudspeakers.
• When using only one surround back speaker, connect it to the left channel.
( R )
> <

Connecting the power supply cord

NOTE:
• Only use the AC OUTLET for audio equipment. Never use it for hair driers, TVs or other
electrical appliances.
• Insert the plugs securely. Incomplete connections will result in the generation of noise.
23
ENGLISH
Connecting Other Sources
Power amplifier
B
CENTER
A
SURROUND
BACK
L L
L
R R
R
A
SURROUND
L L
L
R R
R
B
SUB-
WOOFER
A
FRONT
L L
L
R R
R
Power supply cord
(Supplied)
AC outlets
(wall)
AC 230 V, 50 Hz
AC OUTLET
• SWITCHED (total capacity – 100 W)
The power to the outlet is turned on and off in
conjunction with the POWER switch on the
main unit, and when the power is switched
between on and standby from the remote
control unit.
No power is supplied from this outlet when
this unit's power is at standby. Never connect
equipment whose total power consumption
exceeds 100 W.