Connecting The Antenna Terminals - Denon AVR-3806 Operating Instructions Manual

ENGLISH
Connecting Other Sources
NOTE:
• The audio signals on the multi/stereo area of Super Audio CDs are not output. If the Super
Audio CD is a hybrid CD, only the audio signals in the CD area are output.
• Use a compatible player to play DVD Audio discs that are copyright protected by CPPM.
• Among the devices that support HDMI, some devices can control other devices via the HDMI
connector; however, the AVR-3806 cannot be controlled by another device via the HDMI
connector.
• The audio signals from the HDMI connector (including the sampling frequency and bit length)
may be limited by the equipment that is connected.
• The video signals are not output properly if a device not compatible with HDCP is used.
• Use an HDMI monitor compatible with an HDMI input resolution of 480i or 576i.
• The video signals input from the HDMI input terminals are output to the HDMI monitor with
their original resolution, so the image will not be displayed if the resolutions of the input signal
and the monitor being used are not matched. In this case, change the setting of the resolution
on the source device (player) to one which the monitor can handle.
• For stable signal transfer, we recommend using cables that are a maximum of 5 meters in
length.
• If your digital TV monitor or DVD player only supports DVI-D, please obtain and use an HDMI-DVI
conversion cable or adaptor, available from your dealer.
2 Connections with an HDMI/DVI-D conversion cable (adapter)
• The HDMI video stream signals (video signals) are theoretically compatible with DVI-D. When
connecting to a monitor, etc., equipped with DVI-D terminals, it is possible to connect using an
HDMI/DVI-D conversion cable, but depending on the combination of devices used the image
might not be output.
• When using an HDMI/DVI-D conversion adapter, the image may not be output properly due to
poor contact with the connected cable, etc..

Connecting the antenna terminals

An FM antenna cable plug can be connected directly.
Direction of
broadcasting station
FM Antenna
75 Ω/ohms
Coaxial cable
FM indoor antenna
(Supplied)
2 AM loop antenna assembly
Connect to the AM
antenna terminals.
1 2
Remove the vinyl tie
Bend in the reverse
and take out the
direction.
connection line.
4
a. With the antenna
on top any stable
surface.
Mount
b. With the antenna
attached to a wall.
Installation hole Mount on wall, etc.
21
ENGLISH
Connecting Other Sources
AM loop antenna
(Supplied)
Ground AM outdoor antenna
Connection of AM antennas
1. Push the lever.
3
2. Insert the conductor.
3. Return the lever.
NOTE:
• Do not connect two FM antennas
simultaneously.
• Even if an external AM antenna is used, do
not disconnect the AM loop antenna.
• Make sure the AM loop antenna lead
terminals do not touch metal parts of the
panel.