Getting Started; Operation; Selecting An Input Source - Denon DN-700AV User Manual

Getting Started

Use the Setup Wizard to adjust the following settings:
•
Set the language for the instructions seen on your TV/computer monitor.
•
Set the audio/video source and sound options for each speaker.
•
Configure the settings so that connected devices can be operated using the included remote control.
•
Configure network settings to play audio files from a media server or Internet radio.
1. Connect your surround sound speakers to DN-700AV.
2. Switch your television/computer monitor to the input source connected to DN-700AV's HDMI output.
3. Power on DN-700AV.
4. Press Zone Select to map the Zone 2 to the desired source input.
5. Press Enter to start the Setup Wizard.
6. Follow the Setup Wizard instructions to setup your video and audio sources.

Operation

Selecting an Input Source

To select from the input source options, turn the Source Select knob on the front panel or press one of the
Quick Select buttons. Alternatively, press one of the pre-mapped source buttons on the remote control.
Saving Sources to Quick Select Buttons
1. Use the Source Select knob to select an input source.
2. Press and hold one of the Quick Select buttons for 2 seconds. The selected source will be stored to the
Quick Select location.
Adjusting Individual Surround Channel Volume
Press the Channel Select button on the remote contol to cycle through each of the surround sound channels.
Use the  or  buttons to adjust the individual channel volume.
Adjusting the Master Volume
Adjust the Master Volume using the front panel knob. Alternatively, use the remote control  or  buttons to
adjust the master volume. Press the Mute button on the remote control to turn off the sound temporarily. To
cancel muting, press the Mute button again, adjust the Master Volume knob, or adjust the remote control Vol
+/- buttons.
8