Advanced Setup - Part 2; Speaker Setup; Setting The Type Of Speakers - Denon AVR-3806 Operating Instructions Manual

ENGLISH
Advanced Setup – Part 2
This Speaker Setup section describes the procedures to make speaker settings manually (without using the Auto Setup function),
as well as to make manual changes to settings that have already been made by the Auto Setup function.

Speaker Setup

• If the "Auto Setup" procedure has already been performed, there is no need to make this setting.
• Perform this setting if you wish to make the settings for your speaker systems manually.
ENTER
SYSTEM SETUP CURSOR
SYSTEM
SETUP
CURSOR

Setting the type of speakers

The composition of the signals output to each channels and the
frequency response are adjusted according to the combination of
speakers actually being used.
1
Press the
"Speaker Setup" at "System Setup Menu", then
press the
• The "Speaker Setup" menu appears.
2
Press the
"Speaker Config.", then press the
• The "Speaker Config." screen appears.
ENTER
CURSOR D D H H
or button to select
ENTER
button.
CURSOR D D H H
or button to select
ENTER
button.
73
ENGLISH
Advanced Setup – Part 2
3
CURSOR D D H H
Press the or button to select the
CURSOR F F
speaker, then press the
to select the parameter.
Center Sp.
Front Sp.
Subwoofer
Surround Sp. A
Surround back Sp.
Surround Sp. B
4
ENTER
Press the button to enter the setting.
• The "Speaker Setup" menu reappears.
• Select "Large" or "Small" not according to the actual size of
the speaker but according to the speaker's capacity for playing
low frequency (bass sound below the frequency set for the
Crossover Frequency) signals. If you do not know, try
comparing the sound at both settings (setting the volume to a
level low enough so as not to damage the speakers) to
determine the proper setting.
2 Parameters
Large:
Select this when using speakers that can fully reproduce deep
bass well below the frequency set for the Crossover Frequency
mode.
Small:
Select this when using speakers that are not capable of
handling deep bass well below the frequency set for the
Crossover Frequency mode. Deep bass content in any channel
with a SMALL speaker is routed to the subwoofer(s).
None:
Select this when no speakers are installed.
Yes / No:
Select "Yes" when a subwoofer is installed, "No" when a
subwoofer is not installed.
2spkrs / 1spkr:
Select the number of speakers to be used for the surround back
channel.
G G
or button