Video Setup; Setting The Hdmi In Assign - Denon AVR-3806 Operating Instructions Manual

Advanced Setup – Part 1
4 Repeat step 3 to input the preset channel name.
If you wish to set the preset channel name back to as it was
initially, press the CURSOR H H button with the preset channel
name highlighted.
If the same digital input terminal is selected, the setting for
the input source that was previously assigned switches to
"OFF".
If "Yes" is selected for "Default", the setting are
automatically reset to the default name.
5
Once all the characters have been input, press
ENTER
the button.
• The "Preset Name" screen reappears.
Use the same procedure to change other input source
names as well.
6
CURSOR H H
When the button is pressed at the
very bottom of the screen.
• The screen for the next preset memory block appears.
It is also possible to select the desired preset memory block
by selecting "Block" then pressing the CURSOR F F or G G
button.
7
ENTER
Press the button.
• The "Tuner Presets" screen reappears.
8
ENTER
Press the button to enter the setting.
• The "Audio Input Setup" menu reappears.
9
CURSOR D D H H
Press the or
ENTER
"Exit", then press the button.
• The "System Setup Menu" reappears.

Video Setup

Make the video-related settings.

Setting the HDMI In Assign

• This setting assigns the HDMI input terminals for different
input sources.
• Set the method for playing the audio signals included in the
HDMI input signal.
1
CURSOR D D H H
Press the or
"Video Setup" at "System Setup Menu", then
ENTER
press the button.
• The "Video Setup" menu appears.
2 CURSOR D D H H
Press the or
"HDMI In Assign", then press the
button.
• The "HDMI In Assign" screen appears.
64
ENGLISH
3
Press the
button to select
input source, then press the
button to select the input terminal.
Select from among HDMI1 to 2.
If the same HDMI input terminal is selected, the setting for
the input source that was previously assigned switches to
"NONE".
4
Press the
method for playing the audio signals included in
the HDMI input signal, then press the
F F or G G
button to select "TV" or "AMP".
TV:
Play the audio signals on a monitor TV connected to the AVR-
3806.
AMP:
Play the audio signals on speakers connected to the AVR-
3806.
button to select
5
Press the
input for the playback of signals when the audio
signal of HDMI can not be reproduced, then
press the
input signal (ANALOG or EXT. IN).
button to select
ENTER
When the audio signal of HDMI has become unlocked, the
unit automatically changes over to the set connector
(ANALOG or EXT. IN).
1~2 correspond to each HDMI 1~2 input terminal.
ENGLISH
Advanced Setup – Part 1
CURSOR D D H H
or button to select the
CURSOR F F
or
CURSOR D D H H
or button to select the
CURSOR
CURSOR D D H H
or button to select the
CURSOR F F G G
or button to select the
G G