Starting Auto Setup; Power Amp Assign; Preliminary Measurements - Denon AVR-3806 Operating Instructions Manual

ENGLISH
Easy Setup and Operation

Starting Auto Setup

1
SETUP
Press the button.
• The "System Setup Menu" appears.
2
CURSOR D D
Press the or
"Auto Setup / Room EQ", then press the
button.
• The "Auto Setup / Room EQ" menu appears.
3
CURSOR D D H H
Press the or
ENTER
Setup", then press the
• The "Auto Setup" screen appears.
The message "Connect Microphone" is displayed if no
microphone is connected. If so, connect the auto setup
microphone.

Power Amp Assign

The AVR-3806 has available surround back amplifier channel. If
no surround back speakers are used in the main room, their
amplifier channels can be assigned for multi-zone use or the front
speaker's Bi-Amp connection. If this functionality is not needed,
skip this "Power Amp Assign" procedure and proceed to

"Preliminary measurements".

Press the
Amp Assign", then press the
to select "Surround Back", "Front", "Front B",
"ZONE2" or "ZONE3".
H H
button to select
ENTER
When "Surround Back" is selected, the surround back
channel's test tone during Auto Setup will be output from
surround back speakers.
When "Front" is selected, change the setting to a Bi-Amp
mode for the front speakers.
button to select "Auto
The front channel's test tone during Auto Setup will be
button.
output from the front speakers and the surround back
speakers.
When "Front B" is selected, change the setting to a second
stereo output mode.
The test tone during Auto Setup will not be output from the
surround back speakers.
When "ZONE2" or "ZONE3" is selected, change the
setting to "ZONE2" or "ZONE3".
The test tone during Auto Setup it will not be output to
"ZONE2" or "ZONE3" (Another room).
CURSOR D D H H
or button to select "Power
CURSOR F F G G
or
11
ENGLISH
Preliminary measurements
• This procedure is used to automatically determine the
background noise, whether or not speakers are connected, and
the polarities of the connected speakers.
• To avoid affecting the measurements, turn off the air-
conditioner or any other device that makes noise and take the
measurements with the room as quiet as possible.
• The set measures the background noise even when in the
silent state with no test tones being output, so keep as quiet as
possible until the measurements are completed.
button
1
CURSOR D D
Press the
"Start", then press the
• The preliminary measurements start.
The screen shown at the below appears once the
preliminary measurements are completed.
2
ENTER
Press the button.
•The "Speaker Detect Check" screen appears.
[ First screen ]
Easy Setup and Operation
H H
or button to select
CURSOR F F
button.