Speaker System Measurement; Check Of The Measurement Result - Denon AVR-3806 Operating Instructions Manual

Easy Setup and Operation
3
Check the results of the speaker detection, then
ENTER
press the button.
• The second screen appears.
[ Second screen ]
4
ENTER
If the check ends, press the
NOTE:
• If the results are not as expected or if an error message is
displayed, select "Retry" and perform the measurements
again. (For details on the error messages (
If the results of remeasurement are still not as expected or
if an error message is displayed, turn off the power switch
and check the speaker connections. Then start the
measurements again from the beginning.
• Measurement is cancelled when MASTER VOLUME is
operated while the Auto Setup is performed.

Speaker system measurement

With these measurements, the "Speaker Configuration",
"Distance", "Channel Level", "Crossover Frequency" and
"Room EQ" are analyzed automatically. The main listening
position is measured first, so leave the microphone where it is.
1
CURSOR D D H H
Press the or button to select "OK
CURSOR F F
Start", then press the
• Measurements for the first point start.
The screen shown at the below appears once the
measurements for the main listening position are
completed.
2
Next the measurements for the second point will
be taken.
button again.
Place the microphone at the second listening position. For
instructions on the position in which the microphone should
be placed ( page 9).
3
CURSOR F F
Press the
• Measurements for the second point start.
page 13).
4
Perform step 2, 3 repeatedly.
The more measurement points, the better the resulting room
correction effect. We recommend 6 measurement points – 6
measurement points provides the best room correction effect.
5
After measuring at the number of points
button.
according to your listening environment, press
CURSOR D D
the
"Calculate", then press the
• The speaker system is analyzed.
The results of the measured items can be checked.
1
button.
2
H H
or button to select
CURSOR F F
button.
12
ENGLISH
Easy Setup and Operation
The amount of time required for the analysis depends on the
number of speakers and the number of measuring points.
The greater the number of speakers and measuring points,
the longer the time required.
Measurements can be ended when there are 6 or less
measurement locations; however, to obtain better results,
measurements at 6 locations is recommended.
Once the calculations are completed, a screen for
confirming the results of the measurements appears.

Check of the measurement result

CURSOR D D H H
Press the or button to select an
ENTER
item, then press the button.
• The verification screen appears.
Example: Speaker Config. Check
[ First screen ]
ENTER
Press the button.
• The second screen appears.
Example: Speaker Config. Check
[ Second screen ]
ENGLISH