System Call - Denon AVR-3806 Operating Instructions Manual

ENGLISH
Advanced Operation
MODE SELECTOR

SYSTEM CALL

CHANNEL
System call
The accessorius remote control unit is equipped with "system
call" function allowing a series of remote control signals to be
transmitted by pressing a single button.
This function can be used for example to turn on the amplifier's
power, select the input source, turn on the monitor TV's power,
turn on the source component's power and set the source to the
play mode, all at the touch of a single button.
2 System call buttons
• Up to 32 signals each can be stored at the SYSTEM CALL 1 ~ 3
buttons.
• The System Call function can be used in the SYSTEM CALL
mode.
2 Storing system call signals
1 1
SET UP SETUP
Press and hole the Press and hold the
three seconds. three seconds.
• The IR segment blinks twice. • The IR segment blinks twice.
2
Press the
IR segment
system call setting.
• The IR segment blinks twice.
3
Press the
to register the system call.
4
Press the button you want to register.
• The IR segment blinks once after each key press.
ON
The mode can be switched by pressing a MODE SELECTOR
button.
5
Repeat steps 4 to register the desired buttons.
Up to 32 signals each can be stored at the SYSTEM CALL 1
~ 3.
NUMBER
6
SETUP
Press and hold the
three seconds to register the system call.
• The IR segment blinks twice.
NOTE:
• The remote control signals of the buttons pressed while
registering the system call signals are emitted, so be careful
not to operate the components accidentally (cover the
remote sensors, for example).
button for at least button for at least
button (9 → → 7 7 → → 8 8 ) ) to select
9, 7, 8
SYSTEM CALL
button (1 to 3) you want
SETUP
button for at least
51
ENGLISH
2 Using the system call function
1
AMP
Press the button to select
CALL mode.
2
SYSTEM CALL
Press the button (1 to 3) at which
the system call signals have been stored.
• The stored signals are transmitted successively.
Advanced Operation
SYSTEM