6. Drill the four screw holes (approx. 2 mm) on the wall, then install the mount-
ing base to the wall using four screws.
7. Put the rubber cap on to the nut. The installation is now complete.
Caution!: Before cutting the cable, it must be disconnected from the rear
panel of the transceiver.
The routing cable can be cut and spliced, however care needs to be
taken when reconnecting the wires to ensure water integrity.
After cutting you will notice there are the following wires:
Yellow, White, Brown, Gray, Blue, Green, Red/White
The red/white and shield wires are wrapped in foil. Remove the foil,
and separate the red/white and shield wires.
It is not recommended to plug or unplug the SSM-70H (RAM4) Remote
Station Microphone into the routing cable while the radio is on.
GX6500E/GX6000E
External Speaker Connections
Ferrite Core
Wall
Routing Cable
Mounting Bracket
NOTE
WARNING
Gasket
Cap
Nut
, Shield
Page 27