Viking D3 Installation Manual
Freestanding 30” dual fuel self-clean sealed burner range
Hide thumbs
Also See for D3:
- Use & care manual (26 pages) ,
- User and care manual (24 pages) ,
- Installation manual (12 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Viking D3
Summary of Contents for Viking D3
- Page 1 Installation Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Website at vikingrange.com Freestanding 30” Dual Fuel Self-Clean Sealed Burner Range F20938A EN (070212)
-
Page 2: Table Of Contents
Table of Contents IMPORTANT– Read and ollow! Your safety and the safety of others is • Before beginning, please read these Warnings & Important Safety Instructions_____________________________________________________3 very important. instructions completely and carefully. Dimensions __________________________________________________________________________________6 We have provided many important safety Specifications ________________________________________________________________________________7 messages in this manual and on your •... - Page 3 • Viking Range Corporation will NOT warranty any problems resulting from GFI outlets which according to the manufacturer’s too be used as a heating source.
-
Page 4: Dimensions
Dimensions Specifications Dual Fuel 30” W. Range Dual Fuel 30” W. Range Description RDSCD230-5 - 7 / ( 7 5 8 ” Overall width 29-7/8” (75.9 cm) Overall height To top of side trim – 35-7/8” (91.1 cm) min. 37” (94.0 cm) max. Legs adjust –... -
Page 5: Clearance Dimensions (Proximity To Cabinets)
Clearance Dimensions Clearance Dimensions (Proximity to Cabinets) (Wood/Composite Overlay) • This range may be installed directly • Wall cabinets above the range must be a The bottom of a standard hood should be adjacent to existing 36” (91.4 cm) high minimum of 42”... -
Page 6: Electrical & Gas Requirements
Electrical & Gas Requirements Electrical & Gas Requirements Electrical Requirements IMPORTANT: Any conversion required Flexible Connections: In Canada: CAN 1-6, 10-88 metal Check your national and local codes must be performed by your dealer or a If the unit is to be installed with flexible connectors for gas appliances and regarding this unit. -
Page 7: General Information
The interior unusual or excessive noise coming from the should be washed thoroughly with hot, cooling fan, contact a Viking Authorized soapy water to remove film residues and any Service Center before continuing operation. -
Page 8: Leg Installation
Leg Installation Electrical Connection (3-wire) Note: If you have a 4-wire connection, see following section for 4-wire connection instructions. WARNING WARNING ELECTRICAL SHOCK ELECTRICAL SHOCK HAZARD HAZARD To avoid risk or electrical To avoid risk of electrical shock, shock, personal injury or death; personal injury or death;... -
Page 9: Electrical Connection (4-Wire)
Electrical Connection (3-wire) Electrical Connection (4-wire) (cont.) Bare Wire Connection Eyelet Connection WARNING WARNING ELECTRICAL SHOCK ELECTRICAL SHOCK HAZARD HAZARD To avoid risk or electrical To avoid risk of electrical shock, shock, personal injury or death; personal injury or death; verify grounding product to the frame of the unit your appliance has been properly may or may not be permitted through... -
Page 10: Leveling/Adjustments/Alignment
Electrical Connection (4-wire) Leveling/Adjustments/Alignment (cont.) Bare Wire Connection Eyelet Connection Feed supply cord up through hole in bottom Measure the four corners in cutout area For uneven or sloped floors, level unit with metal shims To make a bare wire connection, use holes on the left to verify if flooring is level. -
Page 11: Anti-Tip Device Installation
Leveling/Adjustments/Alignments Wall Mount Anti-tip Installation (cont.) (cont.) 3 - 5 3 - 5 3 - 5 ( 9 . ( 9 . ( 9 . ” ” ” ( 1 . ( 1 . ( 1 . / 2 ” / 2 ”... -
Page 12: Final Installation
Floor Mount Anti-tip Installation Final Installation (cont.) Remove two screws from back of range. Attach bracket to back of range using two screws. Slide range into place. Be sure Burner heads and burner caps are packed in the anti-tip bracket slides into the anti-tip opening. cardboard top pack with the grates. -
Page 13: Door Replacement And Adjustment
Door Replacement and Adjustment Final Preparation • All stainless steel body parts should be to remove encrusted materials, soak with wiped with hot, soapy water and with a hot, wet cloths to loosen the material, then liquid cleaner designed for this material. use a wool or nylon scraper. -
Page 14: Service & Registration
Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service parts distributor in your area or write to:...