Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Side Trim and Side Panel Removal
1. Remove Door (see Door Assembly Removal)
2. Remove the control panel assembly (see
Control Panel Assembly Removal)
3. Remove backguard assembly, 4 screws.
4. Remove kickplate and lower access grate (see
Access Control Board Assembly Removal,
steps 1 and 2)
5. Remove two keyhole screws from top of side
panel, see photo below
6. Remove screw from bottom rear of panel , see
illustration and photo below
7. Remove side panel and place in a secure area
to prevent damage.
8. Reverse procedures for installation.
42
!
WARNING
Hinge Receiver Removal
1. Remove side panel (see Side Panel Removal).
2. Remove screws and side trim from range.
3. Remove screws and panel from range.
4. Remove screws and hinge receiver from range.
5. Reverse procedure for installation.
Back Panel Removal
1. Remove backguard assembly, 4 screws..
2. Remove screws and access door from back
cover.
©2012 Viking Preferred Service