Oven Light Switch Removal; Door Switch Removal; Oven Light Bulb Removal - Viking DCCG130 Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Oven Light Switch Removal

Condition Requirements:
Control Components Accessed
1. Mark and disconnect two connectors from light
switch.
2. Remove screws and oven light switch from control
panel.
3. Reverse procedure for installation.

Door Switch Removal

Condition Requirements:
Control Components Accessed
1. Remove two screws and door switch from range.
2. Mark and disconnect two connectors from door
switch.
3. Reverse procedure for installation.
24

Oven Light Bulb Removal

Condition Requirements:
Door Lowered
DO NOT touch bulb with bare hands. Clean off any
signs of oil from the bulb and handle with a soft cloth.
1. Unsnap glass light cover using a screwdriver in the
access groove.
2. Firmly grasp light bulb and pull out.
3. Replace with halogen bulb using volt and wattage
requirements listed on glass cover.
4. Replace the light cover by snapping glass cover onto
metal box.
1
3
2
4
©2010 Viking Preferred Service