Adjusting The Bevel Stops - Delta 36-6022 Instruction Manual

MAKING ADJUSTMENTS
a
45°
UNLOCK
LOCK
FIGURE.
FIGURE 49 a
0°
UNLOCK
LOCK
FIGURE.
FIGURE 50

ADJUSTING THE BEVEL STOPS

If the blade is not vertically square with the table, you must adjust the 0-degree positive stop located on the inside of
the bevel track at the left end of the bevel track opening as shown in Figures 50 and 50a.
Unlock the bevel/height adjustment locking lever and position the adjustment wheel to the right in order to gain easy
access to the 0-degree positive stop. Then lock the adjustment lever.
Turn the 0-degree positive stop set screw to right or left to adjust stop location.
Unlock the adjustment wheel, return the blade to the 0-degree position, making sure it makes contact with the
positive stop, and re-lock the adjustment wheel in place.
Recheck the position of the blade to the table surface using a framing square (See "SQUARING THE BLADE
VERTICALLY TO THE TABLE" ON THIS PAGE).
Continue repeating previous two steps until the blade is vertically square to the table.
You can use this same procedure in order to check the 45-degree positive stop, located at the far right end of the
bevel track, just inside the bevel track opening as shown in Figures 49 & 49a.
37