Making Adjustments; Adjusting 90° And 45° Positive Bevel Stops - Delta 36-725 T2 Instruction Manual

ADJUSTING 90° AND 45°
POSITIVE BEVEL STOPS
There are Positive Stops at each end of the Bevel Range. To ensure
accurate cuts, the Positive Stops MUST be positioned at exactly
90° and 45°. The Bevel Stops are properly adjusted as shipped.
However, for maximum accuracy, you should check the position of
the Stops upon assembly and from time to time to assure that the
settings remain satisfactory. To check the position of the Stops and
adjust if necessary, see Figure 26 and do the following:
1.
Release the Center Knob on the Bevel Handwheel, located
on the right side of the Saw by rotating counter-clockwise.
2.
Rotate the Bevel Handwheel counter clockwise and tilt the
Blade to the 0° position until the Stop is reached.
3.
Using a Combination Square
Blade Face to the Table, as shown in Figure 27. Confirm the
blade is at 90° to the table.
4.
If the Blade is not perpendicular to the Table, turn Hand
wheel to slightly tilt the Blade away from the Stop Position
then adjust the 90° Stop by adjusting the Set Screw
located in the Table Top immediately in front of the left
side of Throat Plate
Carpenter's Square and continue to adjust until the Blade is
at 90° when returned to the Stop Position.
5.
Rotate the Bevel Handwheel clockwise until it rests on the
45° Stop. Then repeat Steps 3 and 4, adjusting the 45°
Stop by adjusting the Set Screw located in front of the
right side of the Throat Plate

MAKING ADJUSTMENTS

, check the angle of the
C
. Re-check angle using the
A
.
B
22
B
A
HP21
Figure 26
C
Figure 27