Adjusting The Bevel Stops - Delta 36-6023 Manual

ADJUSTING THE BEVEL STOPS

If the blade is not vertically square with the table, you must adjust the 0-degree positive stop located on the inside of the bevel
track at the left end of the bevel track opening as shown in Figures 41 and 41a.
Unlock the bevel/height adjustment locking lever and position the adjustment wheel to the right in order to gain easy access to the
0-degree positive stop. Then lock the adjustment lever.
Turn the 0-degree positive stop set screw to right or left to adjust stop location.
Unlock the adjustment wheel, return the blade to the 0-degree position, making sure it makes contact with the positive stop, and
re-lock the adjustment wheel in place.
Recheck the position of the blade to the table surface using a framing square (See "SQUARING THE BLADE VERTICALLY TO THE
TABLE" ON THIS PAGE).
Continue repeating previous two steps until the blade is vertically square to the table.
You can use this same procedure in order to check the 45-degree positive stop, located at the far right end of the bevel track
maximum 45°, just inside the bevel track opening as shown in Figures 40 & 40a.
MAKING ADJUSTMENTS
FIGURE 40
FIGURE 41
33
UNLOCK UNLOCK
LOCK LOCK
0°
UNLOCK
LOCK LOCK
a
45°
a