Adjusting 90 And 45 Degree Bevel Stops - Delta ShopMaster MS250 Instruction Manual

ADJUSTING 90 AND 45
DEGREE BEVEL STOPS
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Loosen bevel lock handle and move the cutting arm
all the way to the right. Tighten the bevel lock handle.
2. Place one end of a square (A) Fig. 26 on the table
and the other end against the blade. Check to see if the
blade is 90 degrees to the table (Fig. 26).
3. If an adjustment is necessary, loosen locknut (B)
Fig. 27, and turn screw (C) until head of screw (C)
contacts casting (D) when blade is 90 degrees to the
table. Then tighten locknut (B).
4. Loosen bevel lock handle and move the cutting arm
all the way to the left bevel position and tighten bevel
lock handle.
5. Use a combination square (A) Fig. 28, to see if the
blade is at 45 degrees to the table, as shown.
6. If an adjustment is necessary, loosen locknut (E)
Fig. 29, and turn screw (F) until screw (F) contacts casting
(G) when blade is 45 degrees to the table. Then tighten
locknut (E).
7. Check to see that the bevel pointer P Fig. 29A, is
pointing to the 45 degree mark on the bevel scale (S)
Fig. 28. To adjust the bevel pointer P Fig. 29A, loosen
the screw (H) and adjust pointer (P) and tighten screw
(H) securely.
8. These positive stops enable you to rapidly position
the blade at the 90 and 45 degree bevel angle to the
table.
G
F
E
Fig. 29
P
H
14
A
Fig. 26
B
Fig. 27
A
Fig. 28
Fig. 29A
D
C
S