Adjusting The Blade Height; Changing The Bevel - Delta 36-6022 Instruction Manual

ADJUSTMENT

ADJUSTING THE BLADE HEIGHT

For all through cuts, the top of the blade points should be above the workpiece and the bottom of the blade gullets are
below the top surface of workpiece.
For non-through cuts, the top of the blade points should be set to the depth of the cut.
To adjust the height of the blade, refer to Figure 51 and do the following:
Make sure the bevel/height adjustment locking lever is in the locked position.
Adjust the blade height by turning the bevel/height adjustment wheel. Clockwise will raise the blade and
counterclockwise lowers it.

CHANGING THE BEVEL

Unlock the bevel/height adjustment locking lever by pulling it into the unlock position.
Holding knob/wheel, slide the bevel indicator to the desired angle.
When the blade is at desired angle, lock the bevel/height adjustment locking lever by pushing it down to the lock
position.
See Figure 51.
MAKING ADJUSTMENTS
WHEEL
LOCKING
LEVER
LOCK
FIGURE 51
38
UNLOCK