Front Riggings; Adjusting Footrest Height - Invacare Solara 3G User Manual

10 FRONT RIGGINGS

10 Front Riggings
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur

10.1 Adjusting Footrest Height

Height Adjustment Ranges
 60° footrest - Range:13-17 inches, 70° footrest - Range:13-17 inches, 90° footrest - Range: 5-8 inches, 90° footrest - 5-11
inches (with 3 inch extension)
If using ANY type of extension with the adjustable flip-up footplate. Refer to Adjusting Adjustable Angle Flip-Up Footplates
on page 85.
60°, 70° and 70° Taper
1. Remove the footrest from the wheelchair. Refer to Installing/
Removing Footrests on page 36.
2. Remove the hex screw and coved spacer and slide the footrest up
or down on its mounting tube until the desired footrest height is
achieved.
3. Reassemble the hex screw and coved spacer through the footrest
upper support and mounting tube.
4. Securely tighten the hex screw and coved spacer.
5. Install the footrest assembly onto the wheelchair. Refer to
Installing/Removing Footrests on page 36.
6. Repeat STEPS 1-5 for the opposite side of the wheelchair, if
necessary.
Invacare® Solara®3G/Spree 3G Wheelchair
Hex Screw
Coved
Spacer
FIGURE 1 Adjusting Footrest Height - 60°, 70° and 70° Taper
82
Footrest Upper
Support
Mounting
Tube
Footrest
Part No 1154295