Operation; Installing/Removing Footrests - Invacare Solara 3G User Manual

4 OPERATION

4 Operation
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur
4.1

Installing/Removing Footrests


This procedure applies to the lift off footrest assembly and elevating legrest.
Installing
1. Turn footrest to the side (open footplate is perpendicular to the wheelchair).
2. Insert the footrest assembly mounting pin into the mounting tube of the wheelchair frame.
3. Rotate the footrest towards the inside of the wheelchair until it locks into place.
4. The footplate will be on the inside of the wheelchair when locked in place.
5. Repeat STEPS 1-3 for the other footrest assembly.
6. If necessary, adjust the footrest height. Refer to Adjusting Footrest Height on page 82 or Installing Impact Guards/Calf Strap/H-Calf Strap on
page 38.
Removing
1. Push the footrest release lever inward while rotating the front rigging outward.
2. Lift the footrest assembly out of the mounting pin of the wheelchair frame.
3. Repeat STEPS 1-2 for opposite side, if necessary.
 Only the swing away footrest is shown. The lift off footrest assembly and elevating legrest install/remove in the same
manner.
Invacare® Solara®3G/Spree 3G Wheelchair
36
Part No 1154295