Table of Contents
Advertisement
•
encryption-type: enter 0 for plain text or 7 for encrypted text.
•
password: enter a text string.
NOTE:
You cannot use the change directory (cd) command until you have configured ftp-server
topdir.
To view the FTP configuration, use the show running-config ftp command in EXEC privilege mode.
Configuring FTP Client Parameters
To configure FTP client parameters, use the following commands.
•
Enter the following keywords and the interface information:
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/
subport] information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
•
For a port channel interface, enter the keywords port-channel then a number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
CONFIGURATION mode
ip ftp source-interface interface
•
Configure a password.
CONFIGURATION mode
ip ftp password password
•
Enter a username to use on the FTP client.
CONFIGURATION mode
ip ftp username name
To view the FTP configuration, use the show running-config ftp command in EXEC privilege mode, as
shown in the example for
Terminal Lines
You can access the system remotely and restrict access to the system by creating user profiles.
Terminal lines on the system provide different means of accessing the system. The console line (console)
connects you through the console port in the route processor modules (RPMs). The virtual terminal lines
(VTYs) connect you through Telnet to the system. The auxiliary line (aux) connects secondary devices such as
modems.
Enable FTP
Server.
Management
90
Advertisement
Table of Contents
Troubleshooting
