Table of Contents
Advertisement
*>i 6.10.0.0/15
*>i 6.14.0.0/15
*>i 6.133.0.0/21
*>i 6.151.0.0/16
--More--
Changing MED Attributes
By default, Dell Networking OS uses the MULTI_EXIT_DISC or MED attribute when comparing EBGP paths
from the same AS.
To change how the MED attribute is used, enter any or all of the following commands.
•
Enable MED comparison in the paths from neighbors with different ASs.
CONFIG-ROUTER-BGP mode
bgp always-compare-med
By default, this comparison is not performed.
•
Change the bestpath MED selection.
CONFIG-ROUTER-BGP mode
bgp bestpath med {confed | missing-as-best}
•
confed: Chooses the bestpath MED comparison of paths learned from BGP confederations.
•
missing-as-best: Treat a path missing an MED as the most preferred one.
To view the nondefault values, use the show config command in CONFIGURATION ROUTER BGP mode.
Changing the LOCAL_PREFERENCE Attribute
In Dell Networking OS, you can change the value of the LOCAL_PREFERENCE attribute.
To change the default values of this attribute for all routes received by the router, use the following
command.
•
Change the LOCAL_PREF value.
CONFIG-ROUTER-BGP mode
bgp default local-preference value
•
value: the range is from 0 to 4294967295.
The default is 100.
To view the BGP configuration, use the show config command in CONFIGURATION ROUTER BGP mode or
the show running-config bgp command in EXEC Privilege mode.
A more flexible method for manipulating the LOCAL_PREF attribute value is to use a route map.
1
Enter the ROUTE-MAP mode and assign a name to a route map.
CONFIGURATION mode
195.171.0.16
205.171.0.16
205.171.0.16
205.171.0.16
100
0
209 7170 1455 i
100
0
209 7170 1455 i
100
0
209 7170 1455 i
100
0
209 7170 1455 i
Border Gateway Protocol IPv4 (BGPv4)
250
Advertisement
Table of Contents
Troubleshooting
