Configuring Udf Acl - Dell S4048T Configuration Manual

Dell(conf)#interface TenGigabitEthernet 1/1
Dell(conf-if-te-1/1)#ip access-group testflow in
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
ip address 10.11.1.254/24
ip access-group testflow in
shutdown
Dell(conf-if-te-1/1)#exit
Dell(conf)#do show ip accounting access-list testflow
!
Extended Ingress IP access list testflow on TenGigabitEthernet 1/1
Total cam count 4
seq 5 permit icmp any any monitor count bytes (0 packets 0 bytes)
seq 10 permit ip 102.1.1.0/24 any monitor count bytes (0 packets 0 bytes)
seq 15 deny udp any any count bytes (0 packets 0 bytes)
seq 20 deny tcp any any count bytes (0 packets 0 bytes)
Dell(conf)#do show monitor session 0
ct-maa-s4820-2(conf-mon-sess-0)#do show monitor session 0
SessID Source
------ ------
0 Te 1/1
A

Configuring UDF ACL

To configure a User Defined Field (UDF) ACL:
1 Enable UDF ACL feature on a switch.
CONFIGURATION mode
feature udf-acl
Dell(conf)#feature udf-acl
2 Change the default CAM allocation settings or reconfigure new CAM allocation settings and enable IPV4
UDF.
CONFIGURATION mode
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number
l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos number]
ecfmacl number [nlbclusteracl number] ipv4pbr number }openflow number | fcoe
number} [ipv4udfenable] [iscsioptacl number] [vrfv4acl number]
Dell(conf)#cam-acl l2acl 1 ipv4acl 8 ipv6acl 2 ipv4qos 0 l2qos 2 l2pt 0
ipmacacl 0 vman-qos 0 ecfmacl 0 ipv4udfenable
3 View the currently configured CAM allocation.
EXEC mode
EXEC Privilege mode
Destination
-----------
Te 1/2
Dir Mode Source IP
--- ---- ---------
rx Flow N/A
Access Control Lists (ACLs)
Dest IP
--------
N/
172