Console Access
The device has one RJ-45/RS-232 console port, an out-of-band (OOB) Ethernet port, and a micro USB-B
console port.
Serial Console
The RJ-45/RS-232 console port is labeled on the upper right-hand side, as you face the PSU side of the
chassis.
Figure 1. RJ-45 Console Port
1
RJ-45 management Ethernet port.
Accessing the Console Port
To access the console port, follow these steps:
For the console port pinout, refer to
1
Install an RJ-45 copper cable into the console port.Use a rollover (crossover) cable to connect the
S4810 console port to a terminal server.
2
Connect the other end of the cable to the DTE terminal server.
3
Terminal settings on the console port cannot be changed in the software and are set as follows:
•
115200 baud rate
•
No parity
•
8 data bits
•
1 stop bit
•
No flow control
2
Accessing the RJ-45 Console Port with a DB-9
RS-232 console port.
Adapter.
Getting Started
51