Behavior Of Various Applications For Switch-Initiated Traffic - Dell S4048T Configuration Manual

On system
Table of Contents

Advertisement

EIS is enabled implies that EIS feature is enabled and the application might or might not be configured as
a management application
EIS is disabled implies that either EIS feature itself is disabled or that the application is not configured as
a management application
Transit Traffic
This phenomenon occurs where traffic is transiting the switch. Traffic has not originated from the switch and
is not terminating on the switch.
Drop the packets that are received on the front-end data port with destination on the management port.
Drop the packets that received on the management port with destination as the front-end data port.
Switch-Destined Traffic
This phenomenon occurs where traffic is terminated on the switch. Traffic has not originated from the switch
and is not transiting the switch.
The switch accepts all traffic destined to the switch, which is received on management or front-end data
port. Response traffic with management port IP address as source IP address is handled in the same manner
as switch originated traffic.
Switch-Originated Traffic
This phenomenon occurs where traffic is originating from the switch.
1
Management Applications (Applications that are configured as management applications):
The management port is an egress port for management applications. If the management port is down
or the destination is not reachable through the management port (next hop ARP is not resolved, and so
on), and if the destination is reachable through a data port, then the management application traffic is
sent out through the front-end data port. This fallback mechanism is required.
2
Non-Management Applications (Applications that are not configured as management applications as
defined by this feature):
Non-management application traffic exits out of either front-end data port or management port based
on routing table. If there is a default route on both the management and front-end data port, the default
for the data port is preferred route.
Behavior of Various Applications for Switch-
Initiated Traffic
This section describes the different system behaviors that occur when traffic is originating from the switch:
EIS Behavior: If the destination TCP/UDP port matches a configured management application, a route lookup
is done in the EIS table and the management port gets selected as the egress port. If management port is
down or the route lookup fails, packets are dropped.
Internet Group Management Protocol (IGMP)
447

Advertisement

Table of Contents
loading

Table of Contents