Bgp Configuration - Dell S4048T Configuration Manual

BGP Configuration

To enable the BGP process and begin exchanging information, assign an AS number and use commands in
ROUTER BGP mode to configure a BGP neighbor.
By default, BGP is disabled.
By default, Dell Networking OS compares the MED attribute on different paths from within the same AS (the
bgp always-compare-med command is not enabled).
NOTE: In Dell Networking OS, all newly configured neighbors and peer groups are disabled. To enable a
neighbor or peer group, enter the neighbor {ip-address | peer-group-name} no shutdown
command.
The following table displays the default values for BGP on Dell Networking OS.
Table 12. BGP Default Values
Item
BGP Neighbor Adjacency changes
Fast External Fallover feature
Graceful Restart feature
Local preference
MED
Route Flap Damping Parameters
Distance
Timers
Add-path
Default
All BGP neighbor changes are logged.
Disabled
Disabled
100
0
half-life = 15 minutes
reuse = 750
suppress = 2000
max-suppress-time = 60 minutes
external distance = 20
internal distance = 200
local distance = 200
keepalive = 60 seconds
holdtime = 180 seconds
Disabled
Border Gateway Protocol IPv4 (BGPv4) 226