Dell S4048T Configuration Manual page 42

Table 1. Dell Networking OS Command Modes
CLI Command Mode
EXEC
EXEC Privilege
CONFIGURATION
NOTE: Access all of the
following modes from
CONFIGURATION mode.
AS-PATH ACL
10 Gigabit Ethernet Interface
40 Gigabit Ethernet Interface
Interface Group
Interface Range
Loopback Interface
Management Ethernet Interface
Null Interface
Port-channel Interface
Tunnel Interface
VLAN Interface
STANDARD ACCESS-LIST
EXTENDED ACCESS-LIST
IP COMMUNITY-LIST
AUXILIARY
CONSOLE
VIRTUAL TERMINAL
Prompt
Dell>
Dell#
Dell(conf)#
Dell(config-as-path)#
Dell(conf-if-te-1/1)#
Dell(conf-if-fo-1/52)#
Dell(conf-if-group)#
Dell(conf-if-range)#
Dell(conf-if-lo-0)#
Dell(conf-if-ma-1/1)#
Dell(conf-if-nu-0)#
Dell(conf-if-po-1)#
Dell(conf-if-tu-1)#
Dell(conf-if-vl-1)#
Dell(config-std-nacl)#
Dell(config-ext-nacl)#
Dell(config-community-
list)#
Dell(config-line-aux)#
Dell(config-line-console)#
Dell(config-line-vty)#
Access Command
Access the router through the
console or terminal line.
• From EXEC mode, enter the
enable command.
• From any other mode, use
the end command.
• From EXEC privilege mode,
enter the configure
command.
• From every mode except
EXEC and EXEC Privilege,
enter the exit command.
ip as-path access-list
interface (INTERFACE modes)
interface (INTERFACE modes)
interface(INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
interface (INTERFACE modes)
ip access-list standard (IP
ACCESS-LIST Modes)
ip access-list extended (IP
ACCESS-LIST Modes)
ip community-list
line (LINE Modes)
line (LINE Modes)
line (LINE Modes)
Configuration Fundamentals 42