Wiring Of The Pm-E F Pp Dc24V Profisafe - Siemens SIMATIC ET 200S Installation And Operating Manual

Caution
If high currents can occur on DO 2 P and DO 2 M, both terminals 11 and 15 (P) and
terminals 12 and 16 (M) must be wired in parallel.
Otherwise, the current loading could cause the terminals to heat up.
7.3.3

Wiring of the PM-E F pp DC24V PROFIsafe

Block Diagram
Figure 7-12
ET 200S Distributed I/O System - Fail-Safe Modules
Hardware Installation and Operating Manual, 07/2005, A5E00103686-04
Block Diagram of the PM-E F pp DC24V PROFIsafe
7.3 PM-E F pp DC24V PROFIsafe power module
Fail-Safe Modules
7-29