Configuring
2.2 Assigning Modules of an ET 200S
2.2
Assigning Modules of an ET 200S
2.2
Introduction
This section presents the following module assignments for ET 200S:
• F-power modules to terminal modules
• F-electronic modules to terminal modules
• Power modules to electronic modules/motor starters
Assigning F-Power Modules to Terminal Modules
You can use the F-power modules with the following terminal modules:
Table 2-1
F-Power Modules
PM-E F pm DC24V PROFIsafe
and
PM-E F pp DC24V PROFIsafe
PM-D F DC24V PROFIsafe
Assigning F-Electronic Modules to Terminal Modules
You can use the following fail-safe electronic modules and terminal modules together:
Table 2-2
F-Electronic Modules
4/8 F-DI DC24V PROFIsafe
and
4 F-DO DC24V/2A PROFIsafe
2-4
Assigning F-Power Modules to Terminal Modules
Terminal Modules
TM-P30S44-A0 (screw-in type)
TM-P30C44-A0 (snap-in type)
TM-PF30S47-F1 (screw-in type)
Assigning F-Electronic Modules to Terminal Modules
Terminal Modules
TM-E30S46-A1 (screw-in type)
TM-E30C46-A1 (snap-in type)
TM-E30S44-01 (screw-in type)
TM-E30C44-01 (snap-in type)
Hardware Installation and Operating Manual, 07/2005, A5E00103686-04
For a Description, See ...
ET 200S Distributed I/O
system
For a Description, See ...
ET 200S Distributed I/O
system
ET 200S Distributed I/O System - Fail-Safe Modules
manual
manual