Wiring; Wiring Diagram - Siemens SIMATIC ET 200SP Equipment Manual

Wiring

4.1

Wiring diagram

This section contains the pin assignment for the module.
You can find information on wiring the BaseUnit in the ET 200SP Distributed I/O System
(http://support.automation.siemens.com/WW/view/en/58649293) System Manual.
NOTE
The load group of the module must begin with a light-colored BaseUnit. Also keep this in
mind during configuration.
NOTICE
You may only use the digital output module with a type A0 BaseUnit.
With the type A1 BaseUnit, the integrated fuse can be triggered, rendering the terminals
unusable.
NOTE
Cross circuit at output
Be aware that voltage from a cross circuit at the output can feed L+ to modules.
Pin assignment: 1-wire connection of actuators
The following table shows an example of the pin assignment of the digital output module DQ
16x24VDC/0.5A HF on the BaseUnit BU type A0 without AUX terminals:
Description
Digital output, channel 0
Digital output, channel 2
Digital output, channel 4
Digital output, channel 6
Digital output, channel 8
Digital output, channel 10
Digital output, channel 12
Digital output, channel 14
24 V DC supply voltage
16
Signal Terminal BaseUnit BU type A0
DQ 1
0
1
DQ 3
2
3
DQ 5
4
5
DQ 7
6
7
DQ 9
9
8
11
DQ 11
10
13
DQ 13
12
15
DQ 15
17
14
L+ 17
Terminal Signal Description
2
2
4
CC00
4
6
6
8
8
10
10
12
12
14
14
16
16
18
18
Digital output module DQ 16x24VDC/0.5A HF (6ES7132-6BH00-0CA0)
Equipment Manual, 01/2024, A5E52818470-AA
DQ Digital output, channel 1
1
DQ Digital output, channel 3
3
DQ Digital output, channel 5
5
DQ Digital output, channel 7
7
DQ Digital output, channel 9
9
DQ Digital output, channel 11
11
DQ Digital output, channel 13
13
DQ Digital output, channel 15
15
M Ground
4