Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System; Cleaning The Parksense System - Jeep WRANGLER 2020 Owner's Manual

260 STARTING AND OPERATING

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the climate controls.
ParkSense Switch
When the ParkSense switch is pushed to disable
the system, the instrument cluster display will
show the "PARKSENSE OFF" message for
approximately five seconds. Refer to "Instrument
Cluster Display" in "Getting To Know Your
Instrument Panel" for further information. When
the gear selector is moved to REVERSE and the
system is disabled, the instrument cluster display
will show the "PARKSENSE OFF" message for as
long as the vehicle is in REVERSE (Not in 4L).
The ParkSense switch LED will be on when
ParkSense is disabled or requires service.
The ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed, and requires service, the ParkSense
switch LED will blink momentarily, and then the
LED will be on.
Service The ParkSense Rear Park Assist
System
During vehicle start up, when the ParkSense Rear
Park Assist System has detected a faulted
condition, the instrument cluster display will
actuate a single chime, once per ignition cycle,
and it will display the "PARKSENSE UNAVAILABLE
WIPE REAR SENSORS" or the "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message.
Refer to "Instrument Cluster Display". When the
gear selector is moved to REVERSE and the
system has detected a faulted condition, the
instrument cluster display will show the
"PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" or "PARKSENSE UNAVAILABLE
SERVICE REQUIRED" message for as long as the
vehicle is in REVERSE. Under this condition,
ParkSense will not operate.
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" appears in the instrument cluster
display, make sure the outer surface and the
underside of the rear fascia/bumper is clean
and clear of snow, ice, mud, dirt or other
obstruction and then cycle the ignition. If the
message continues to appear, see an
authorized dealer.
If "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" appears in the instrument cluster
display, see an authorized dealer.

Cleaning The ParkSense System

Clean the Rear Park Assist sensors with water,
car wash soap and a soft cloth. Do not use
rough or hard cloths. In washing stations, clean
sensors quickly keeping the vapor jet/high
pressure washing nozzles at least 4 inches
(10 cm) from the sensors. Do not scratch or
poke the sensors. Otherwise, you could damage
the sensors.