IBM V7000 Introduction And Implementation Manual page 639

Follow this procedure to configure the Call Home event notification function:
1. If the step to configure Support Notifications (Step 5 of 7) was complete already during
initial setup, as shown in Figure 13-43 and Figure 13-44, besides sending a test email to
check that all connections and infrastructure are set up correctly, no further Call Home
configuration is required.
Figure 13-43 Configure email event notification during initial setup
2. To enable the Call Home event notification function, go to IBM Flex System V7000 Storage
Node management GUI  Settings  Event Notifications  Email  Enable Email
Event Notification, as shown in Figure 13-44.
Figure 13-44 Enable email event notification after the initial setup is complete
Chapter 13. Maintenance and troubleshooting
619