IBM V7000 Introduction And Implementation Manual page 496

4. Assign ports to FCoE VLAN.
5. Enable FCF (you must have at least one FC-Port to enable FCF).
It is necessary to complete the aforementioned steps in the correct order for the configuration
to be successful. In Example 11-1, the ISCLI commands display shows that the Omni ports
EXT11-12 are changed from their Ethernet default to Fibre Channel after the Converged
Enhanced Ethernet (CEE) and FCoE Initialization Protocol (FIP) snooping is enabled. The
FCoE VLAN is then created and then the ports are assigned to the VLAN.
Example 11-1 Configuring ports, creating VLAN and port assigning
Router>enable----------------------------------------> Enable privilege granted
Router#configure terminal---> Enter configuration commands, one per line. End
with Ctrl/Z
Router(config)#cee enable-----------------------------------------> CEE Enabled
Router(config)#fcoe fips enable---------------------------------> FIPS Enabled
Router(config)#system port EXT11-EXT12 type fc ---------------> FC Mode Enabled
Router(config)#
Oct 26 14:22:12 fd8c:215d:178e:c0de:3640:b5ff:fe5c:f5ef NOTICE lldp: LLDP TX & RX
are disabled on port EXT11
Oct 26 14:22:12 fd8c:215d:178e:c0de:3640:b5ff:fe5c:f5ef NOTICE lldp: LLDP TX & RX
are disabled on port EXT12
Router(config)#vlan 1002
VLAN 1002 is created---------------------------------------------->VLAN Created
Router(config-vlan)#member INTA3-INTA4,INTA11-------------> Ports added to VLAN
Port INTA3 is an UNTAGGED port and its PVID is changed from 1 to 1002
Port INTA4 is an UNTAGGED port and its PVID is changed from 1 to 1002
Port INTA11 is an UNTAGGED port and its PVID is changed from 1 to 1002
Router(config-vlan)#member EXT11-EXT12--------------------> Ports added to VLAN
Router(config-vlan)
Example 11-2 shows that all ports were successfully added to VLAN 1002 with VLAN
enabled.
Example 11-2 Display VLAN and ports
Router(config-vlan)#show vlan
VLAN
---- -------------------------------- ------ --- -------------------------
1 Default VLAN
1002 VLAN 1002
4095 Mgmt VLAN
Router(config-vlan)#
The next step is to enable Fibre Channel Forwarding (FCF). Example 11-3 shows the ISCLI
command fcf enable run where, on completion, FCoE connections are established.
Example 11-3 Enable Fibre Channel Forwarding
Router(config-vlan)#fcf enable----------------------------------->FCF Enabled
Router(config-vlan)#
476
IBM Flex System V7000 Storage Node Introduction and Implementation Guide
Name Status MGT
ena
ena
ena
Ports
dis INTA1 INTA2 INTA5-INTA10
INTA12-INTA14 EXT1 EXT2
EXT11-EXT16
dis INTA3 INTA4 INTA11 EXT11
EXT12
ena EXTM MGT1