IBM V7000 Introduction And Implementation Manual page 525

Notice that the zone is associated with the required zoneset as specified when the zone was
created and named in Figure 11-47 on page 504.
Activating the zoneset
The aliases and zones have been created and placed in the zoneset; all that is required now
is to activate the zoneset. To do so, highlight the zone that you want to activate with the
mouse and click Apply in the bottom right side corner of the window as shown in
Figure 11-49. When you are prompted to save the zoning, click Save Zoning. To continue if
you are satisfied with the configuration changes you have made, click Yes.
Figure 11-49 Activate zoneset - order of tasks
505
Chapter 11. SAN connections and configuration