Panasonic DBS 40 Operating Manual page 200

Chapter 4. Key Telephone Features
Related Programming
Considerations
4-90
Technical Manuals Online! - http://www.tech-man.com
5. Press ON/OFF again.
l
FF3 (Extensions): PSD Name Display (5 or 10 Names)
l
FF6 (Name): PSD Names
l
Personal Speed Dial numbers can contain up to sixteen characters,
l
including the "*," "#," "-", FLASH, PAUSE (REDIAL), CONF, and
AUTO keys.
A dash (,'-") can be displayed in the Personal Speed Dialing number. To
l
display a dash. press the FF6 key where you want the dash to appear. The
dash will not appear during programming but will appear when the number
is dialed or checked.
A flash may be entered by pressing the FLASH key.
l
l
"ERROR" appears on the display. If this happens, start again from step 1.
Storing a new number erases any previously stored data.
l
Names for Personal Speed Dialing can be programmed using a DSS
l
console at the Attendant Phone.
If the called party's number and name are stored in the Personal Speed Dial
l
code, that information appears on the display when you use the speed dial
code.
Speed Dial numbers cannot be checked while Station Lockout is activated.
l
With CPC-ALI and CPC-B Version 7.0 and higher, if the Speed Dial is used
l
to forward to an outside number and Least Cost Routing is enabled, the
Speed Dial cannot use Trunk Access "9." Use trunk access 81-86 instead.
DBS Manual - Issued 8/l/95
Section 700 - Operation