Fuel Unit Removal; Fuel Unit Inspection; Fuel Gauge Inspection - KYMCO SUPER 9 50 Service Manual

16
. INSTRUMENT/SWITCHES/LIGHTS
FUEL UNIT
＊
No Smoking!
REMOVAL
Remove the frame body cover. ( 2-3)
Disconnect the fuel unit wire connectors.
Turn the fuel unit retainer counterclockwise
to remove it.
＊
Do not damage the fuel unit wire.
Remove the fuel unit.
＊
Be careful not to bend or damage the
fuel unit float arm.
INSPECTION
Remove the fuel unit.
Measure the resistance between the fuel unit
wire terminals with the float at upper and
lower positions.
Wire Terminals
G～Y/W
G～L/W
Y/W～L/W

FUEL GAUGE INSPECTION

Connect the fuel unit wire connectors and
turn the ignition switch "ON".
＊
Before performing the following test,
operate the turn signals to determine
that the battery circuit is normal.
Check the fuel gauge needle for correct
indication by moving the fuel unit float up
and down.
Float Position
Upper
Lower
Upper Lower
33Ω 686Ω
566Ω 53Ω
600Ω 600Ω
Needle Position
"F" (Full)
"E" (Empty)
Fuel Unit
Fuel Unit Wire
Y/W
SUPER 9 50
G
L/W
16-2