Engine Removal - KYMCO SUPER 9 50 Service Manual

5
. ENGINE REMOVAL/INSTALLATION

ENGINE REMOVAL

Remove the frame body cover. ( 2-2)
Remove the brake fluid tube bolt of the rear
brake caliper.
Remove the rear brake caliper bolt and the
rear brake caliper.
Disconnect the oil pump control cable from
the pump body.
Disconnect the oil inlet line from the oil
pump.
＊
After the oil inlet line is disconnected,
plug the oil line opening to prevent oil
from flowing out.
Disconnect the auto bystarter, A.C.
generator, thermosensor wire couplers and
starter motor wire connectors.
Disconnect the fuel tube and vacuum tube
that go to the carburetor from the
.
valve
Remove the spark plug cap.
Drain the coolant. ( 3-10)
Disconnect the water hose.
Rear Brake Caliper
Auto Fuel Valve
auto fuel
Oil Pump Control Cable
SUPER 9
Water Hose
50
Clamp
Bolt
Oil Inlet Line
AC Generator Wire
Connector
Spark Plug Cap
5-2