Float Chamber Assembly; Float Level Inspection - KYMCO SUPER 9 50 Service Manual

12
. CARBURETOR

FLOAT CHAMBER ASSEMBLY

Install the main jet and needle jet holder.
Install the air screw and throttle stop screw
according to the rotations recorded.
＊
If the air screw must be replaced, be
sure to perform the air screw adjustment
again.
Install the float valve, float and float pin.
Tighten the float screw securely.

FLOAT LEVEL INSPECTION

Slightly tilt the carburetor and measure the
float level with the float valve just
connecting the float arm.
Float Level: 8.6 mm
Replace the float if the level is out of the
specified level range.
Install the O-ring.
Check the operation of the float and install
the float chamber.
Tighten the screws.
12-9
Needle Jet holder
Throttle Stop Screw
Float Pin
SUPER 9 50
Main Jet
Air Screw