12
. CARBURETOR
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• When working with gasoline, keep away from sparks and flames..
• Note the locations of O-rings when disassembling and replace them with new ones during
assembly.
• All cables, fuel lines and wires must be routed and secured at correct locations.
• Bleed air from the oil lines whenever they are disconnected.
SPECIFICATIONS
Venturi dia.
Identification number
Float level
Main jet(Unlimited/limited speed)
Slow jet
Air screw opening
Idle speed
Throttle grip free play
SPECIAL TOOL
Float level gauge
TROUBLESHOOTING
Engine does not start
• No fuel in tank
• Too much fuel getting to cylinder
• Clogged fuel filter
• Clogged air cleaner
Engine idles roughly, stalls or runs poorly
• Incorrect idle speed
• Ignition malfunction
• Compression too low
• Incorrectly adjusted air screw
• Incorrect float level
12-1
SH10DA
2000±100rpm
Lean mixture
• Clogged fuel jets
• Clogged fuel cap vent
• Clogged fuel filter
• Bent, kinked or restricted fuel line
• Clogged air cleaner
• Intake air leaks
• Fuel contaminated
• Faulty reed valve
• Clogged fuel jets
SUPER 9
14mm
C
PB093
8.6mm
#92/#78
#35
±
1
¼
½
2~6mm
• Faulty float valve
• Float level too low
• Clogged air cleaner
Rich mixture
• Faulty float valve
• Float level too high
• Clogged air jets
50
SF10DA
C
PB058
1900±100rpm