Step 7: Perform The Initial Software Configuration; Enter Configuration Mode; Configure User Accounts And Passwords - Juniper SRX5600 Getting Started Manual

SRX5600 Services Gateway Getting Started Guide

Step 7: Perform the Initial Software Configuration

Enter Configuration Mode

Configure User Accounts and Passwords

20
This procedure connects the services gateway to the network but does not enable it to
forward traffic. For complete information about enabling the services gateway to forward
traffic, including examples, see the appropriate Junos operating system (Junos OS)
configuration guides at
www.juniper.net/techpubs/
To configure the software:
Enter Configuration Mode on page 20
Configure User Accounts and Passwords on page 20
Configure System Attributes on page 21
Commit the Configuration on page 21
If you have not already done so, switch the circuit breaker or toggle switch for each
1.
power supply to the
ON
faceplate should blink, and then light steadily.
Log in as the root user. There is no password.
2.
Start the CLI.
3.
root# cli
root@>
Enter configuration mode.
4.
configure
[edit]
root@#
Set the root authentication password by entering a cleartext password, an encrypted
1.
password, or an SSH public key string (DSA or RSA).
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
Configure an administrator account on the device. When prompted, enter the password
2.
for the administrator account.
[edit]
root@# set system login user admin class super-user authentication
plain-text-password
New password: password
Retype new password: password
.
position to start the device. The LED on the power supply
OK
Copyright © 2013, Juniper Networks, Inc.