Step 6: Perform Initial Software Configuration - Juniper SRX 5600 Getting Started Manual

SRX 5600 Services Gateway Getting Started Guide
4.
5.
NOTE: For information about connecting to external DC power sources, see the
instructions for your site.
6.
7.

Step 6: Perform Initial Software Configuration

This procedure connects the device to the network but does not enable it to forward
traffic. For complete information about enabling the device to forward traffic, including
examples, see the appropriate JUNOS software configuration guides.
To configure the software:
1.
2.
3.
4.
5.
18
Step 6: Perform Initial Software Configuration
Secure the power cable lugs to the terminal studs on the power supply, first
f.
with the split washer, then with the nut. Apply between 23 lb-in. (2.6 Nm)
and 25 lb-in. (2.8 Nm) of torque.
Replace the clear plastic cover over the terminal studs on the faceplate.
g.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to an approved site ESD grounding point. See the instructions
for your site.
Connect each DC power cable to the appropriate external DC power source.
Switch on the external circuit breakers to provide voltage to the DC power source
cable leads.
Switch on the circuit breakers on each power supply to the
Observe the status LEDs on each power supply faceplate. If a DC power supply
is correctly installed and functioning normally, the
INPUT OK LEDs light green steadily.
If you have not already done so, switch the circuit breaker or toggle switch for
each power supply to the
power supply faceplate should blink, then light steadily.
Log in as the root user. There is no password.
Start the CLI.
root# cli
root@>
Enter configuration mode.
configure
[edit]
root@#
Set the root authentication password by entering either a cleartext password,
an encrypted password, or an SSH public key string (DSA or RSA).
[edit]
root@# set system root-authentication plain-text-password
New password: password
ON position to start the device. The
ON position ( | ).
, , and
PWR OK BRKR ON
OK LED on the