Table of Contents
Advertisement
U S I N G U S E R V E A N D U C L I E N T
To prepare the printer to run an application, you must copy the
application's files to it from the PC. To do so:
1. Establish a connection between the printer and PC.
2. Copy files between the units.
E s t a b l i s h i n g a P C / P r i n t e r C o n n e c t i o n
You must establish a connection between the PC and the printer using
the UClient and UServe software that runs on the PC and printer,
respectively. To establish this connection:
1. Connect the printer and PC with a cable (part number 124054).
2. Turn on the printer and type USERVE at the DOS prompt. You will
see:
USERVE 1.04 READY
_
Using UServe and UClient 7-1
7
Advertisement
Table of Contents
