Table of Contents
Advertisement
LCD [ o p t i o n s ... ]
You can enter one or more of the following options on the
command line.
Y
Enable the display. This option is the default.
N
Disable the display.
F
Set the display speed to fast.
S
Set the display speed to slow.
C
Clear display. Using this command is equivalent to
using the cls command.
D
Backlight off.
L
Backlight on.
K e y p a d
The following table describes the keypad's data entry modes.
These are described in more detail in the Equipment Manual.
Mode
Numeric/Symbol
Alphabetic
Special Key
Normally, when entering data, the operator must enter and exit
the modes manually. However, with the Kbd functions
described in Chapter 4, an application can also change between
the modes automatically.
Using the trigger is a special case of Function Key mode. See
"Reading Trigger Presses" in Chapter 6 for more information.
2-4 Programmer's Manual
Acceptable Keys
Default. Numbers and Symbols
Letters
Function Keys
Advertisement
Table of Contents
