Print Position - Paxar 9856 Operator's Handbook Manual

3.
Press or
want, press
P r i n t P o s i t i o n
This function adjusts where data prints vertically on the supply. Adjust the
print if it is too close to the top or bottom of the supply, or overtypes the
pre-printed area. One dot is 0.0033 inch.
If the data is too close to the bottom, increase the number.
If the data is too close to the top, decrease the number.
Changing this setting only affects new formats sent to
To change the setting, from the Main Menu, select Setup, then Supply.
Then, follow these steps.
1. Press or
2. Press
3-4 Setting Supply Options
to see the other option. After you display the option you
. Press
until you see
SUPPLY
Print Pos
. You will see the current setting, for example:
Enter print pos
[-99/99]: +0
twice to exit to the Main menu.
the printer.