Table of Contents
Advertisement
Tear Bar Installation
The tear bar is already fastened to the printer. To use the tear bar, remove
the rewind bracket and replace the thumbscrews.
Rewind Bracket
Thumbscrews
Using the Internal Rewind Option
The internal rewind option must be purchased separately.
When large quantities of labels are printed as single batches or for later
use, you may use the internal rewind hub to roll up the label supply
automatically for convenient handling.
To use the Supply Rewind Hub:
1.
Open the side access door.
2.
Install a roll of labels, and pull the supply through the printer until
approximately 18 inches is free in front of the unit.
Tear Bar
Loading Supplies
2-5
Advertisement
Table of Contents
