Positioning; Print Position - Paxar 9855 Operator's Handbook Manual

P o s i t i o n i n g
This menu includes selections to change the print, supply, margin,
cut, and dispense positions along with the backfeed distance.
When you see
Feed/Cut acts as a toggle switch to change the value by 10 or 1.
For example, to make the print position 23 (from the default of 0),
press Feed/Cut, then press r twice (20), press Feed/Cut again
and press r three times (23).
P r i n t P o s i t i o n
This function adjusts where data prints vertically on the supply.
Adjust the print if it is too close to the top or bottom of the supply,
or overtypes the pre-printed area. One dot is 0.0049 inch.
N
If the data is too close to the bottom, increase the number.
N
If the data is too close to the top, decrease the number.
Changing this setting only affects new
Enter print pos
[-99/99]: +0
formats sent to the printer.
Setting Supply Options 4-7